Arduino
Ultimate Kit
Contents
  • 25 resistors (5 of each: 100R, 220R, 330R, 1K, 10K)
  • 15 LEDs (5 of each: Red, Yellow, Green)
  • 1N4148 small signal diode
  • 10K miniature preset potentiometer
  • 5 miniature "tact" switches (2-pin, 6mm square)
  • 830 tie-point breadboard
  • 400 tie-point breadboard
  • 170 tie-point breadboard
  • Miniature speaker (12mm diameter, 40 ohm)
  • 9V PP3 battery connector for Arduino
  • 65 male-male jumper wires
  • 16 chars by 2 line LCD module with blue backlight
  • HC-SR04 Ultrasonic distance sensor
  • 4x light dependent resistors (LDR - light sensor)
  • DHT11 digital humidity sensor
  • LM35DZ analog temperature sensor
  • 2x SW-520D tilt switches (non-mercury)
  • 2x 10K full size variable resistor (potentiometer)
  • Dual 7-segment display
  • Quad 7-segment display
  • 8x8 Dual colour (Red/Green) LED matrix
  • 2 stepper motors with ULN2003 control boards (darlington drivers)
  • 20 Female-Male connecting wires (20cm)
  • 2 HC595 8-bit shift registers
  • SD Card reader module
  • Tower Pro 9g micro servo
  • Infrared remote control, transmitter and receiver
LCD and Sensor Kit
  • 16x2 line LCD with blue backlight (including header
  • 4x Light sensing resistors (LDR)
  • Tilt switch (SW-520D)
  • Temperature sensor (LM35DZ)
  • Humidity sensor (DHT-11)
Ultra-Sonic Rangefinder HC-SR04
4 pins - can plug directly into breadboard
5V, 0V, Ping and Echo
Send pulse on Ping pin from Arduino digital output
Measure width of pulse on the Echo pin with Arduino digital input
Stepper Motors
2x 28BYJ48 stepper motors
2x ULN2003 driver boards
7-Segment Displays
  • 2-digit Red display with decimal points. Common Anode. 0.56" high digits
  • 4-digit Red display with colon. Common Anode. 0.56" high digits.
8x8 Red/Green Bi-Colour LED Matrix
24-pin package: 8 columns, 8 Red rows, 8 Green rows
Enable both Red and Green to get Orange
To drive every possible combination with a Uno you will need additional devices such as a shift register
See the LED Matrix page for detailed usage information

 

8-Bit Shift Registers 74HC595
Add extra outputs to the Arduino
Ideal for use with the 7-Segmentdisplays and the 8x8LED Matrix
Shift the 8 outputs bits into the shift register from one pin of the Arduino (uses two others for clock and enable)
Using one shift register adds 5 output pins
Using two shift registers adds 13 output pins
Please also see the Arduino tutorial