|
Super Kit Contents
Contents
- 25 resistors (5 of each: 100R, 220R, 330R, 1K, 10K)
- 15 LEDs (5 of each: Red, Yellow, Green)
- 1N4148 small signal diode
- 10K miniature preset potentiometer
- 5 miniature "tact" switches (2-pin, 6mm square)
- 830 tie-point breadboard
- 400 tie-point breadboard
- Miniature speaker (12mm diameter, 40 ohm)
- 9V PP3 battery connector for Arduino
- 65 male-male jumper wires
- 16 chars by 2 line LCD module with blue backlight
- HC-SR04 Ultrasonic distance sensor
- 2x light dependent resistors (LDR - light sensor)
- DHT11 digital humidity sensor
- LM35DZ analog temperature sensor
- SW-520D tilt switch (non-mercury)
- 10K full size variable resistor (potentiometer)
- Dual 7-segment display
- Quad 7-segment display
- 8x8 Dual colour (Red/Green) LED matrix
- 2 stepper motors with ULN2003 control boards (darlington drivers)
- 20 Female-Male connecting wires (20cm)
|
 |
LCD and Sensor Kit
|
- 16x2 line LCD with blue backlight (header strip provided)
- 2x Light sensing resistors (LDR)
- Tilt switch (SW-520D)
- Temperature sensor (LM35DZ)
- Humidity sensor (DHT-11)
| |
|
 |
| Ultra-Sonic Rangefinder HC-SR04 |
4 pins - can plug directly into breadboard
|
|
5V, 0V, Ping and Echo
Send pulse on Ping pin from Arduino digital output
Measure width of pulse on the Echo pin with Arduino digital input | |
 |
|
 |
7-Segment Displays
|
- 2-digit Red display with decimal points. Common Anode. 0.56" high digits
|
- 4-digit Red display with colon. Common Anode. 0.56" high digits.
| |
 |
| 8x8 Red/Green Bi-Colour LED Matrix |
|
24-pin package: 8 columns, 8 Red rows, 8 Green rows
Enable both Red and Green to get Orange
To drive every possible combination with a Uno you will need additional devices such as a shift register
See the LED Matrix page for detailed usage information
|
| |
